Amana STANDARD CLEANING GAS RANGE Specifications download pdf (Page 12)

ELECTRODE MOUNTING

Each electrode pushes into a

clip (compression sleeve),

which mounts to each of the

four orifice holders. This

allows the electrode to be

removed without lifting the

top. To remove the

electrode, grasp it with your

finger and thumb and pull

upward. A slight twisting

action may help in removing

the electrode. All four

electrodes MUST be

removed prior to lifting the

top.

HOLDER, ORIFICE

To improve alignment and stability the 4 burner orifice brackets

(holders) have been modified. The brackets are mounted to the

cooktop with three "T-15" torx screws. The screw heads are

located under the burner head. These screws MUST be

removed prior to lifting the cooktop. The rigid mounting system

ensures proper alignment of the orifice for gas to be injected

into the burner head.

BURNER HEAD

The burner head has a flame stability

chamber which protects a small pocket of

flame. This small pocket of flame provides

quick reignition, in the event of a minor

burner flame outage during simmer. It also

provides an additional measure of safety.

The burner head also provides a positive

target area for the Ignitor.

BURNER

HEAD

IGNITOR

COOK TOP REMOVAL

COOK TOP RAISED POSITION

– 10 –

COOK TOP / SURFACE BURNERS

TO RAISE OR REMOVE COOK TOP

FOR REMOVAL:

IMPORTANT COOK TOP REINSTALLATION NOTES:

Before lowering the top onto the front clips, feed the electrode

leads through each opening in the cook top. Next be sure that the

electrode clips are inserted into each of the orifice brackets (see

illustration below). Line up the orifice brackets with the holes in

the cook-top and start the screws, which secure the cook-top to

the orifice holders. Before tightening the screws be sure to check

the electrode leads to ensure that they do not get pinched

between the cook top and the orifice holder. Reconnect the

electrode wires and gently push each of the electrodes into

position.

When reinstalling the top, position the top to be the equivalent of

1/2 way lowered, before attempting to insert the top hinge pins

into the corresponding slots on the back-guard.

Remove 4 burner caps and 4 burner heads

Remove 4 electrodes (pull up on the electrode while gently

rotating at the same time) & disconnect electrode leads.

Remove (12) T-15 torx screws which mount the orifice holders

to the cook top

Disengage the 2 front clips using a flat screw driver and gently

raise the top high enough for the prop rods to hold it upright.

Disengage the prop rods from the range slide panels

While raising the front of the cooktop, lower the rear of the cook

top and shift the top left or right in order to disengage the hinge

pins at the rear.

GRATE

BURNER HEAD

BURNER CAP

PAN

ELECTRODE

CLIP

(Compression

Sleeve)

COMPRESSION

NUT

TUBE

ORIFICE

COOK TOP

SCREWS

HOLDER,

ORIFICE

Flame Stability

Chamber

T-15 Torx

Screws

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 33 34

Comments to this Manuals

No comments

Amana STANDARD CLEANING GAS RANGE Specifications Page 12

Comments to this Manuals

Related products and manuals for Cookers Amana STANDARD CLEANING GAS RANGE