Amana PACKAGE HEAT PUMP User Manual download pdf (Page 4)

blower section, to allow splicing-in of field-installed wiring, or con-

nect to terminal strip in unit control box.

See the unit wiring diagram for electrical connections.

C/X G Y R O W W1 W2

C/X G Y R O W1 W2 EROOM THERMOSTAT

OUTDOOR UNIT

PH__C02E

Wiring shown is for D9945804 (THSMEC1H2BA) thermostat.

C/X G Y R O W W1 W2

C/X G Y R O W2 E

ROOM THERMOSTAT

OUTDOOR UNIT

PH__C02E

Wiring shown is for 10636701(THSADC1H2BA) or

10636702 (THSMDC1H2BA) thermostat

C/X G Y R O W W1 W2

C G Y2 Y1 R O W1 W2 W3

ROOM THERMOSTAT

OUTDOOR UNIT

PHD60C02E

(HEATER KIT CONTROL BOX)

Yellow No. 20 Wire in Blower Section

Wiring shown is for

1213412 (1F95-371) thermostat.

C G Y Y1 R O W

C G Y2 Y1 R O W1 W2 W3

ROOM THERMOSTAT

Wiring shown is for 1213412 (1F95-371) thermostat.

NOTE: If Electric Heater Kit is not installed or low voltage connection is made

in unit control box, connect as follows.

OUTDOOR UNIT

PHD60C02E

(CONTROL BOX)

PHD60 TWO-STAGE

C/X G Y R O W W1 W2

C/X G Y R O W1 W2 E

ROOM THERMOSTAT

OUTDOOR UNIT

PH__CC2E

Wiring shown is for D9945804 (THSMEC1H2BA) thermostat.

C/X G Y R O W W1 W2

C/X G Y R O W2 EROOM THERMOSTAT

OUTDOOR UNIT

PH__CC2E

Wiring shown is for 10636701(THSADC1H2BA) or

10636702

(

THSMDC1H2BA

)

thermostat

Typical Thermostat and Unit 24 Volt Wiring Hoo2kup

ELECTRICAL CONNECTIONS

NOTE: The units are designed for operation on 60 Hz current and at

the voltages shown on the rating plate. All internal wiring in the unit is

complete. For the PHB**CC and PHD**CC units, the power supply

connection for the heater and unit will be at the circuit breaker in the

heater control box. For all others, the power supply may be brought

into the contactor (refer to unit wiring diagram supplied with unit).

Ensure 24 volt wiring is connected between the unit control panel

and the room thermostat. See the following figures for low voltage

field connection.

Fork Lift From

Back Of Unit

Rigging

DUCT CONNECTIONS

HORIZONTAL AIRFLOW INSTALLATIONS

(24, 30, 36, 42 AND PHB48 MODELS)

Two three-inch collar connections and two square flanges are shipped

with the unit. The collar connections are located in the return air

opening of the unit. The square flanges are inside the unit blower

compartment. The square flanges can be used for either connect-

ing 16x16 ductwork to the unit or used with a Horizontal Duct Cover

kit (CHK001A).

To install the collar connections, remove the two collars, reverse and

snap them back into place in the outlet and inlet openings. Be sure

the flanges are to the outside of the unit. Secure with screws pro-

vided.

HORIZONTAL AIRFLOW INSTALLATIONS

(PHD48/60 and PHB60 models only)

These units are equipped with 14x14 square supply and return air

openings for horizontal air flow. The openings are flanged for ease

of duct connection. A 16x16 Horizontal Duct Cover kit (CHK001A)

can be used with the clips provided with the unit.

THERMOSTAT PLACEMENT

Thermostat should be mounted 5 feet above the floor, on a vibration

free inside wall in a room or a hallway that has good air circulation.

Movement of air should not be obstructed by furniture, door, draper-

ies, etc. The thermostat should not be mounted where it will be af-

fected by drafts, hot or cold water pipes or air ducts in walls, radiant

heat from fireplace, lamps, the sun, television, etc. Consult the In-

struction Sheet packaged with thermostat for mounting instructions.

WARNING

ISCONNECT ALL ELECTRICAL POWER BEFORE ELECTRICALLY CONNECTING

OR SERVICING THIS UNIT.

AILURE TO DISCONNECT THE ELECTRICAL POWER

BEFORE WORKING ON THIS PRODUCT CAN CREATE A HAZARD LEADING TO

PERSONAL INJURY AND/OR DEATH.

SHOCK

HAZARD

THERMOSTAT WIRING

When an electric heater is installed, the thermostat wiring will be

made at the heater accessory box.

If a unit is installed without electric heaters, the low voltage wiring to

the blower section can be cut, either in the control box area or in the

1 2 3 4 5 6 7 8 9 ... 19 20

Comments to this Manuals

No comments

Amana PACKAGE HEAT PUMP User Manual Page 4

Comments to this Manuals