Amana Bottom-Freezer Operations Instructions download pdf (Page 8)

21.Slidestainlesssteelclipoverwallof icemaker

watercup.

Stainless steel clip

22. Remove 3 button plugs from left freezer wall with a

knife covered with masking tape. Discard plugs.

23. Start 5/8" (15 mm) sheet metal screw in top front

hole on left wall with a 1/4" hex nut driver. Leave

head out approximately 3/8" (9 mm).

24. Hold ice maker in position. Ice maker can only be

installed one way. Do not drill additional holes.Insert

wire harness plug into receptacle on rear wall until

locking fingers on top and bottom of plug snaps into

place. Slide ice maker hanger over sheet metal

screw. Ease ice maker water cup toward end of

water fill tube elbow. Water fill tube elbow fits under

stainless steel clip. Water fill tube elbow must not

be kinked. Water fill tube elbow should extend

approximately 3/8" (9 mm) into ice maker water cup

and must be secured under stainless steel clip.

25. Insert and tighten remaining 5/8" (15 mm) sheet

metal screws with a 1/4" hex nut driver.

26. Replace freezer shelf by sliding in until back locks in

place. Replace wire basket by sliding in. Position ice

storage bucket on wire section of freezer shelf under

ice maker. Confirm bucket is in the proper position.

27. Check for leaks at household water connection and

water valve. Correct any leaks.

28. Create service loop using extreme care to avoid

kinks. Secure copper tubing to refrigerator

cabinet using "P" clamp.

29. Move refrigerator in place and level if necessary.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Amana Bottom-Freezer Operations Instructions Page 8