Amana Free-O-Frost? User Manual download pdf (Page 6)

Door Panel and

Dispenser Trim Installation Instructions

Tools Needed -- Standard Straight

Screwdriver, Phillips Screwdriver,

1/4" Hex Nut Driver and Tightly

Fitted Gloves

1. Remove screw from both top

and bottom handle end cap. See

Figure 12 and 13.

i

Bottom

End Cap

FIGURE 12 FIGURE 13

2. Remove end caps and place

aside until needed. See

Figure 14.

FIGURE 14

5, Remove screws retaining handle,

See Figure 16, Handles will

easily fall away. If you have a

conventional model skip to step

number 10, If you have a

dispensing model proceed with

step number 6.

FIGURE 16

6. Dispenser Trim parts are shipped

separately and are located in

the top crisper drawer in the

refrigerator compartment.

(Dispensing Modets Oniy.)

3. Slide out gray vinyl decorator

strip located in the inset of the

handle. See Figure 15.

FIGURE 15

, CAUTION:

To Avoid Personal Injury

securely hold onto the door

handles while removing screws.

4. NOTE: Screws are in at an

angle -- DO NOT scratch

handle edge.

.

g.

FIGURE 17

These trim pieces are designed

to fit above AND below the

dispenser and provide a groove

for panel installation. See

Figure 17. (Dispensing Models

Only.)

To install the decorator trim

gently slide the trim into the

groove above the dispenser as

shown in Figure 17. (Dispensing

Models Only.)

To install the 2nd piece of trim

below the dispenser follow the

directions in step 8. See

Figure 17 for placement.

(Dispensing Models Only.)

CAUTION:

To Avoid Property Damage

take care not to tilt or start

panel at an angle, to do so _yill

cause panel to jam and may

damage the trim.

m

6

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

Comments to this Manuals

No comments