Amana PTH123G35CXXX User Manual download pdf (Page 10)

10

www.amana-ptac.com

Product Specifications: PTH Models — Reverse-Cycle Heating Performance

H

C

PTH073G

**AXXX

PTH093G

**AXXX

PTH123G

**AXXX

PTH153G

**AXXX

PTH074G

**AXXX

PTH094G

**AXXX

PTH124G

**AXXX

PTH154G

**AXXX

Voltage 

,

 230 / 208 230 / 208 230 / 208 230 / 208 265 265 265 265

BTU/h  6,800 / 6800 8,300 / 8,100 11,500 / 11,300 13,800 / 13,600 6,800 8,300 11,400 13,700

Amps  3.9 / 3.9 4.2 / 4.2 5.8 / 5.8 7.0 / 7.0 3.1 3.7 5.0 6.1

Watts  585 / 585 715 / 700 1085 /1035 1350 / 1330 585 715 1080 1340

COP  3.4 / 3.4 3.4 /3.4 3.1 / 3.2 3.0 / 3.0 3.4 3.4 3.1 3.0

CFM (Dry) 370 360 370 410 370 360 370 410

COP = Coeiciency of Performance; per AHRI Test Procedures, units are rated for capacities and eiciencies.

N

 All 265-volt models must use an Amana® brand sub-base (PTSB4**E) or an Amana® brand hard-wire kit (PTPWHWK4).

 Minimum branch circuit ampacity ratings conform to the National Electric Code; however, local codes should apply.

 Minimum voltage on 230/208-volt models is 197 volts; maximum is 253 volts.

Minimum voltage on 265-volt models is 239 volts; maximum is 292 volts.

 Overcurrent protection for all units without electric heaters is 15 amps. Overcurrent protection on 265-volt models must

be cartridge-style time-delay fuses (included and factory-installed on all Amana® brand 265-volt chassis).

 Heating capacity and eiciency based on unit operation without condensate pump; unit automatically switches to electric

heat at approximately 24°F outdoor ambient.

 Specify two-digit heater kW size to complete model number.

 R-410A refrigerant used in all systems.

 All units meet or exceed ASHRAE 90.1 standards.

 All units less than 250 volts have a Leak Current Detector Interrupter (LCDI) power cord and meet UL 484 standards.

 Refer to electric heat performance data for total MCA and recommended overcurrent protection.

Amps and Watts notation refers to compressor only.

Product Specifications: PTC / PTH Models — Electric Heat Performance

(Primary Heating for PTC Models; Auxiliary Heating for PTH Models; See below for Power Cord Configuration)

V

E

H

S (W)

N. 

S

N H (BTU/)

T

W

T

A

M. C

A

MOP

()

P

C

@ V @ V @ V

230/208V 1.5 / 1.3 1 5,100 4,200 - - 1,570 / 1,295 6.8 / 6.2 8.5 15 6-15 P

230/208V 2.5 / 2.1 1 8,500 6,800 - - 2,570 / 2,115 11.2 / 10.1 14.1 15 6-15 P

230/208V 3.5 / 3.0 1 12,000 9,900 - - 3,570 / 2,935 15.5 / 14.1 19.5 20 6-20 P

230/208V 5.0 / 4.1 1 17,100 14,000 - - 5,070 / 4,160 22.1 / 20.0 27.6 30 6-30 P

265V 1.5 1 - - - - 5,100 1,570 5.9 7.4 15 7-20P

265V 2.5 1 - - - - 8,500 2,570 9.7 12.2 15 7-20 P

265V 3.7 1 - - - - 12,600 3,770 14.2 17.9 20 7-20 P

265V 5 1 - - - - 17,100 5,070 19.2 23.9 25 7-30 P

N

 All 265-volt models must use an Amana® brand sub-base (PTSB4**E) or an Amana® brand hard-wire kit (PTPWHWK4).

 Minimum branch circuit ampacity ratings conform to the National Electric Code; however, local codes should apply.

 Minimum voltage on 230/208-volt models is 197 volts; maximum is 253 volts. Minimum voltage on 265-volt models is 239 volts; maximum is 292 volts.

 Overcurrent protection for all units without electric heaters is 15 amps. Overcurrent protection on 265-volt models must be cartridge-style

time-delay fuses (included and factory-installed on all Amana® brand 265-volt chassis).

 Heating capacity and eiciency based on unit operation without condensate pump; unit automatically switches to electric heat at

approximately 24°F outdoor ambient.

 Total watts for 15,000 BTU/h models; subtract 20 watts for PT07/09/12

 Specify two-digit heater kW size to complete model number.

 R-410A refrigerant used in all systems.

 All units meet or exceed ASHRAE 90.1 standards.

 All units less than 250 volts have a Leak Current Detector Interrupter (LCDI) power cord and meet UL 484 standards.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Comments to this Manuals

No comments