Amana URCS511A Operations Instructions download pdf (Page 21)

Disassembly Procedures

To avoid risk of electrical shock, personal injury, or

death, disconnect power to oven and discharge

capacitors before following any disassembly procedure.

WARNING

Splatter Shield Removal

NOTE: Be careful not to bend antenna when removing

splatter shield. Shield snaps into a lip in front of

the oven and three slots in back.

1. Place your thumbs in the two indentations in front of

the shield.

2. Press lightly towards the back and carefully lower

shield away from antenna.

3. Pull shield out of the back slots and tilt sideways to

remove from oven cavity.

Antenna and Cradle

NOTE: Antenna assembly is mounted in a cradle. The

antenna is located in a plastic tower in the

middle of the cradle.

1. Remove outer case and splatter shield.

2. Remove two mounting nuts on top of oven cavity to

remove cradle. Support cradle before removing

mounting nuts to avoid damage to antenna

assembly.

Antenna

Cradle

tower

Cradle

Larger end of

cradle goes to

left rear side

of cavity.

Rotating Antenna Installation

NOTE: Antenna and cradle must be free of any burrs

for proper operation.

1. Carefully place antenna onto cradle tower.

2. Position cradle into mounting holes in cavity with

larger end toward back and install mounting nuts.

Be careful not to overtighten.

Blower Motor or Wheel Removal

NOTE: Blower wheel does not have set screw but has a

“D” type hole in the hub and clip on end of motor

shaft.

1. Disconnect power to oven.

2. Remove outer case, see “Outer Case Removal”

procedure.

3. Disconnect wiring from blower motor.

4. Remove screw securing scroll bottom to partition.

Blower

Motor

Blower

Scroll

Blower

Wheel

Scroll

Bottom

5. Remove screws from base pan bottom to plastic

scroll legs.

6. Slide scroll discharge from partition and lift scroll

assembly from unit.

7. Unsnap metal bottom from scroll.

8. Remove blower wheel clip and wheel.

9. Remove motor mounting screws from scroll.

Door Disassembly

Old Door Assembly

(unit with P13258* manufacturing number)

1. Open door fully.

2. Remove ten Y–drive screws from inner door. (Use

R0193574 driver.)

3. Remove inner door.

4. Remove handle insert and handle.

5. Remove outer door.

6. Remove door ring and latch handle assembly by

removing screws on side of the door.

Retainer

lens

Outer

window

Outer

door

Door

hinge

Door

ring

weld

Inner

window

Inner

door

Door latch

assembly

Door

handle

Handle

insert

Gasket

Rivet

Door

latch

spring

*Use Manual Driver Part Number R0193574.

1 ... 20 21 22 ... 38

Comments to this Manuals

No comments

Amana URCS511A Operations Instructions Page 21

Comments to this Manuals

Related products and manuals for Microwaves Amana URCS511A