Amana AER6303MFS Installation Manual

INSTALLATION INSTRUCTIONS30" (76 CM) FREESTANDING ELECTRIC RANGESTable of ContentsRANGE SAFETY ...

104. Use a Phillips screwdriver to connect the green ground wire from the power supply cord to the range with the ground-link screw and ground-link se

111. Part of metal ground strap must be cut out and removed.2. Use a Phillips screwdriver to remove the ground-link screw from the back of the range.

122. Attach terminal lugs to line 2 (red), bare (green) ground, and line 1 (black) wires. Loosen (do not remove) the setscrew on the front of the term

136. Repeat steps 1 and 2 to ensure that the range foot is engaged in the anti-tip bracket.If the rear of the range lifts more than ½" (1.3 cm) o

14Storage Drawer(on some models)The storage drawer can be removed. Before removing, make sure drawer is cool and empty.To Remove:1. Pull the storage d

15Moving the RangeWhen moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.If removing the range is necessary f

W10403811C®/™ ©2012 Whirlpool. All rights reserved.8/12Printed in U.S.A.

2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All

3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w

4Product DimensionsIMPORTANT: Range must be level after installation. Follow the instructions in the “Level Range” section. Using the cooktop as a ref

5Electrical Requirements - U.S.A. OnlyIf codes permit and a separate ground wire is used, it is recommended that a qualified electrical installer dete

6INSTALLATION INSTRUCTIONSUnpack Range1. Remove shipping materials, tape and film from range.2. Remove oven racks and parts package from inside oven.3

7Floor MountingWall Mounting5. Using the Phillips screwdriver, mount anti-tip bracket to the wall or floor with the two #12 x 1⁵⁄₈" screws provid

8Electrical Connection - U.S.A. Only1. Disconnect power.2. Remove the terminal block cover screws located on the back of the range. Pull cover down an

9Style 2: Direct wire strain relief Remove the knockout as needed for the flexible conduit connection. Assemble a UL listed conduit connector in the