Amana AGG222VDW Dimensions Guide download pdf

20" (50.8 cm) Freestanding Gas Range

PRODUCT MODEL NUMBERS PRODUCT DIMENSIONS

CABINET OPENING DIMENSIONS

AGG222VD

Because Whirlpool Corporation policy includes a continuous commitment to improve

our products, we reserve the right to change materials and specifications without notice.

Dimensions are for planning purposes only. For complete details, see Installation

Instructions packed with product. Specifications subject to change without notice.

Electrical Requirements:

●

A 120 volt, 60 Hz., AC only, 15-amp fused, electrical circuit is required. A time-delay

fuse or circuit breaker is also recommended. It is recommended that a separate circuit

serving only this range be provided.

●

This range is equipped with a power supply cord having a 3 prong ground plug. To

minimize possible shock hazard, the cord must be plugged into a grounded 3 prong

outlet.

●

Electronic ignition systems operate within wide voltage limits, but proper grounding

and polarity are necessary. Check that the outlet provides 120-volt power and is

correctly grounded.

This range is equipped with an electronic ignition system that will not operate if

plugged into an outlet that is not properly polarized.

Gas Supply Requirements:

Natural gas:

This range is design-certified by CSA International for use with Natural gas or, after

proper conversion, for use with LP gas.

●

This range is factory set for use with Natural gas. See “Gas Conversions” section. The

model/serial rating plate located on the oven frame behind the left side of the broiler

door has information on the types of gas that can be used. If the types of gas listed do

not include the type of gas available, check with the local gas supplier.

LP gas conversion:

Conversion must be done by a qualified service technician.

No attempt shall be made to convert the appliance from the gas specified on the

model/serial rating plate for use with a different gas without consulting the serving gas

supplier. See “Gas Conversions” section.

Gas Supply Line

●

Provide a gas supply line of ³⁄₄" (1.9 cm) rigid pipe to the range location. A smaller size

pipe on longer runs may result in insufficient gas supply. With LP gas, piping or tubing

size can be ¹⁄₂" (1.3 cm) minimum. Usually, LP gas suppliers determine the size and

materials used in the system.

NOTE: Pipe-joint compounds that resist the action of LP gas must be used. Do not

use TEFLON

®†

tape.

Flexible metal appliance connector:

●

If local codes permit, a new CSA design-certified, 4-5 ft (122-152.4 cm) long, ¹⁄₂"

(1.3 cm) or ³⁄₄" (1.9 cm) I.D., flexible metal appliance connector may be used for

connecting range to the gas supply line.

●

A ¹⁄₂" (1.3 cm) male pipe thread is needed for connection to the female pipe threads of

the inlet to the appliance pressure regulator.

●

Do not kink or damage the flexible metal tubing when moving the range.

Rigid pipe connection:

The rigid pipe connection requires a combination of pipe fittings to obtain an in-line

connection to the range. The rigid pipe must be level with the range connection. All

strains must be removed from the supply and fuel lines so range will be level and in line.

●

Must include a shutoff valve:

The supply line must be equipped with a manual shutoff valve. This valve should be

located in the same room but external to the range opening, such as an adjacent

cabinet. It should be in a location that allows ease of opening and closing. Do not block

access to shutoff valve. The valve is for turning on or shutting off gas to the range.

Ref. W10459123B

3/19/13

(65.9 cm)

(50 cm)

(106.6 cm)

For minimum

clearance to

top of cooktop,

see NOTE.

This shaded area

recommended for

installation

of gas pipe.

This shaded area

recommended for

electrical outlet.

18" (45.7 cm)

min. clearance

upper side

cabinet to

countertop

13" (33.0 cm) max.

upper cabinet depth

opening width

20" (50.8 cm) min.

cabinet opening width

(14 cm)

(5.1 cm)

(6.4 cm)

(10 cm)

10" (25.4 cm)

3" (7.6 cm) min.

countertop space to

side wall or other

combustible material

24"

(61.0 cm)

NOTE: 24" (61 cm) minimum when bottom of wood or metal cabinet

is covered by not less than ¹⁄₄" (0.64 cm) flame retardant millboard

covered with not less than No. 28 MSG sheet steel, 0.015" (0.4 mm)

stainless steel, 0.024" (0.6 mm) aluminum or 0.020" (0.5 mm) copper.

30" (76.2 cm) minimum clearance between the top of the cooking

platform and the bottom of an uncovered wood or metal cabinet.

IMPORTANT: If installing a range hood or microwave hood

combination above the range, follow the range hood or microwave

hood combination installation instructions for dimensional clearances

above the cooktop surface.

†®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.

A. Gas supply line

B. Shutoff valve “open” position

C. To range

AGG222VD 1

Summary of Contents

Page 1 - AGG222VD

20" (50.8 cm) Freestanding Gas RangePRODUCT MODEL NUMBERS PRODUCT DIMENSIONSCABINET OPENING DIMENSIONSAGG222VDBecause Whirlpool Corporation polic

Amana AGG222VDW Dimensions Guide

Browse online or download Dimensions Guide for Ovens Amana AGG222VDW. Amana AGG222VDW Dimension Guide User Manual

Summary of Contents

More documents for Ovens Amana AGG222VDW

Comments to this Manuals

Amana AGG222VDW Dimensions Guide

Browse online or download Dimensions Guide for Ovens Amana AGG222VDW. Amana AGG222VDW Dimension Guide User Manual

Summary of Contents

More documents for Ovens Amana AGG222VDW

Comments to this Manuals

Related products and manuals for Ovens Amana AGG222VDW