Amana PBH093G35CC User Manual download pdf (Page 11)

ADDITIONAL INFORMATION

• The remote control will operate all the control panel features.

Instructions will be the same.

• The “COOL” circuit has an automatic 3 minute time de-

layed start if the unit is turned off and on quickly. This

prevents overheating of the compressor and possible cir-

cuit breaker tripping.

NOTE: The fan will continue to run during this time.

• The control will maintain any set temperature between 60°F

and 90°F (cooling), 55°F and 80°F (heating).

• The control is capable of displaying temperature in degrees

(Fahrenheit) or degrees (Celsius). To convert from one to the

other, press and hold the UP and DOWN Temperature Selec-

tion Pads at the same time for 3 seconds.

COMPRESSOR

The compressor is hermetically sealed, permanently lubricated

and requires no additional oiling.

FRONT PANEL AND GRILLE

The front panel and grille can be cleaned with a mild soap or

detergent. Do not use hydrocarbon-based cleaners (e.g. acetone,

benzene, naphtha, gasoline, etc.) to clean the front panel or grille.

Use care when cleaning the control area. Do not use an exces-

sively wet cleaning cloth.

SCHEDULED MAINTENANCE

To achieve continuing top performance and high efficiency, a regular

cleaning/inspection schedule must be established. Maintaining

this schedule can be accomplished by either a local maintenance

staff or an authorized servicer and must follow the instructions

described in this manual.

• If the unit is operated in a dusty climate, dust may collect in

the basepan and clog the condenser coil. It is advisable to

remove the unit from the sleeve and thoroughly clean the

basepan and condenser coil on a periodic basis.

• If the unit is installed ocean side or in a corrosive atmosphere,

its life may be greatly reduced by the corrosive environment.

Under these conditions, the unit should be removed from the

sleeve and completely cleaned once a year. At that time any

scratches or blisters on the painted surfaces should be

sanded and repainted.

OUTDOOR COIL CLEANING

The coils on the outdoor side of the air conditioner should be

checked regularly. For cleaning outside coil, remove the 6 screws

that mount the condenser coil top cover to condenser shroud.

NORMAL OPERATING SOUNDS

AND CONDITIONS

POPPING OR GURGLING SOUNDS

This sound is the refrigerant traveling through the lines. This is a

normal sound which may be heard for a few seconds after the unit

shuts off.

WATER TRICKLING SOUNDS

This sound is produced by the water as it is picked up and run

over the coils. This procedure improves the efficiency of the unit

and helps with water removal.

WATER DRIPPING

Water will collect in the basepan during high humidity days.

STARTING DELAY

You may notice a short delay in the startup if you try to restart the

unit too soon after turning it off or if you adjust the thermostat right

after the compressor has shut off. This delay protects the com-

pressor.

Obtaining Service

In the unlikely event this unit requires repair or servicing beyond

what is covered in this manual, contact an authorized service or-

ganization.

To obtain an authorized servicer, contact your sales representa-

tive or agency.

1 ... 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Amana PBH093G35CC User Manual Page 11

Comments to this Manuals

Related products and manuals for Unknown Amana PBH093G35CC