INSTALLATION INSTRUCTIONS30" (76.2 CM) FREESTANDING GAS RANGESTable of ContentsRANGE SAFETY...
10IMPORTANT: If the back of the range is more than 2" (5.1 cm) from the mounting wall, the rear range foot may not engage the bracket. Slide the
11Check Operation of Oven/Broil BurnerElectronic oven control (on some models):1. Open broiler door. 2. Press in and turn the oven control knob to the
12GAS CONVERSIONSGas conversions from Natural gas to LP gas or from LP gas to Natural gas must be done by a qualified installer.LP Gas Conversion1. Tu
132. Remove the cap from the gas pressure regulator using a flat-blade screwdriver.NOTE: Be sure sealing washer remains in the same position.3. To con
143. Locate LP gas orifice spud stamped “56” in the bag containing literature supplied with the range.4. Use a ³⁄₈" combination wrench and remove
152. Remove the cap from the gas pressure regulator using a flat-blade screwdriver.NOTE: Make sure sealing washer remains in the same position.3. To c
To Convert Oven Burner1. Open the oven door and remove oven racks and oven tray with flame spreader and set aside.2. Remove screw from the oven burner
2RANGE SAFETYYou can be killed or seriously injured if you don't immediately You can be killed or seriously injured if you don'tfollow All
3INSTALLATION REQUIREMENTSTools and PartsGather the required tools and parts before starting installation. Read and follow the instructions provided w
4Location RequirementsIMPORTANT: Observe all governing codes and ordinances. Do not obstruct flow of combustion and ventilation air. It is the insta
5Cabinet DimensionsCabinet opening dimensions shown are for 25" (64.0 cm) countertop depth, 24" (61.0 cm) base cabinet depth and 36" (9
6Gas Supply RequirementsObserve all governing codes and ordinances. IMPORTANT: This installation must conform with all local codes and ordinances. In
7Burner Input RequirementsInput ratings shown on the model/serial rating plate are for elevations up to 2,000 ft (609.6 m).For elevations above 2,000
83. Determine and mark centerline of the cutout space. The mounting can be installed on either the left side or right side of the cutout. Position mou
9Complete Connection1. Locate gas pressure regulator in the back of the range.IMPORTANT: Do not remove the gas pressure regulator.2. Check that the ga
Comments to this Manuals