Amana PTC093E35AXXXAB Specifications download pdf (Page 26)

26

WARNING

HIGH PRESSURE AND HIGH TEMPERATURE CLEAN-

ING IS NOT RECOMMENDED. DOING SO COULD

DAMAGE THE ALUMINUM FIN STOCK AND ELEC-

TRICAL COMPONENTS.

CLEARANCE CHECK

Clearances around the unit should also be checked to make

sure that the intake air and discharge air paths have not be-

come blocked or restricted. A minimum of eight inches clear-

ance is needed from unit to furniture, beds, or other objects for

proper operation. Restricted discharge or intake air will reduce

the units operational performance. In severe airflow restrictions

damage can occur to unit components such as the compres-

sor, electric heater or fan motor.

NORMAL OPERATING SOUNDS AND

CONDITIONS

Water Trickling Sounds

Water is picked up and distributed over the coil. This

improves the efficiency and helps with water removal.

Water Dripping

Water will collect in the base pan during high humidity days.

This can cause overflow and drip from the outside of the unit.

Air Sounds

The fan cycle switch sets the operational mode of the fan in

the on position. When the unit is in conditioning mode for ex-

ample high or low heat or cool, the fan will run continuously. In

the AUTO position , the fan will cycle on and off with the com-

pressor or electric heater.

Starting Delay

You may notice a few minutes delay in the starting if you try to

start the unit too soon after turning the unit off. This is due to a

built in delay to protect the compressor.

MAINTENANCE

1 ... 25 26 27 ... 69

Comments to this Manuals

No comments