Amana LD510D Service Manual Page 26

  • Download
  • Add to my manuals
  • Print
  • Page
    / 26
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 25
Disassembly Procedures
To avoid the risk of electrical shock, personal injury, or
death, disconnect power to oven and discharge
capacitors before following any disassembly procedure.
WARNING
!
26 16022150 Rev. 0 ©2003 Maytag Appliances Company
Fan Motor
1. Disconnect power to oven and remove outer case
(see "Outer Case" section).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Remove rear air guide.
4. Remove screws securing diode to back panel.
5. Disconnect and label wires to high voltage capacitor.
6. Remove screws securing fan shroud to back panel
and remove fan shroud from cavity.
7. Disconnect wires from fan motor terminals.
8. Carefully note fan blade direction and placement on
motor shaft.
9. Pull fan blade from motor shaft.
10. Remove screws securing motor to shroud and
remove motor.
11. Reassemble in reverse order.
Motor
Fan shroud
Rear air guide
Blade
Cavity Thermostat
The cavity thermostat is located on top left side of cavity.
Thermostat is a non–resettable thermostat.
1. Disconnect power to oven and remove outer case,
(see "Outer Case" section).
2. Discharge high voltage capacitor, (see "High Voltage
Capacitor" section).
3. Carefully bend one tab to release thermostat.
4. Disconnect wires from oven thermostat and replace
thermostat.
5. Reassemble in reverse order.
Light Socket / Bulb Assembly
1. Disconnect power to oven and remove outer case,
(see "Outer Case" section).
2. Disconnect wire terminal plug.
3. Carefully bend one tab to release socket.
4. Remove light socket / bulb assembly.
5. Replace and reassemble in reverse order.
Stirrer Motor
1. Disconnect power to oven.
2. Place oven on it's back.
3. Remove bottom plate cover, by cutting metal tabs
NOTE: When reinstalling plate cover use screw
provided.
4. Disconnect wires from motor terminals.
5. Remove screws securing motor to oven cavity.
Stirrer motor
Wire leads
6. Replace and reassemble in reverse order.
Page view 25
1 ... 25 26

Comments to this Manuals

No comments