Amana LD510D Service Manual download pdf (Page 8)

WARNING

To avoid risk of electrical shock, personal injury or

death, make sure these earthing instructions are

followed.

Earthing Instructions

WARNING

Do not remove earthing prong when installing earthed

appliance in a home or business that does not have

three wire earthing receptacle, under no condition is

earthing prong to be cut off or removed. It is the

personal responsibility of the consumer to contact a

qualified electrician and have properly earthed three

prong wall receptacle installed in accordance with

appropriate electrical codes

Should a two prong adapter plug be required temporarily,

it is the personal responsibility of the consumer to have it

replaced with properly earthed three prong receptacle or

the two prong adapter properly earthed by a qualified

electrician in accordance with appropriate electrical

codes.

Servicing of Earthed Products

The standard accepted color coding for earthing wires is

GREEN or GREEN WITH YELLOW STRIPE. These

earth leads are NOT to be used as current carrying

conductors. It is extremely important that the technician

replace any and all earths prior to completion of the

service call. Under no condition should earth wire be left

off causing a potential hazard to technicians and

consumer.

WARNING

Precautions to be observed before and during

servicing to avoid possible exposure to excessive

microwave energy, or electrical shock disconnect

power to oven.

(A) Do not operate or allow oven to be operated with

door open.

(B) Make the following safety checks on all ovens to

be serviced before activating the magnetron or

other microwave source, and make repairs as

necessary:

• Interlock operation

• Proper door closing

• Seal and sealing surfaces (arcing, wear, and

other damage)

• Damage to or loosening of hinges and latches

• Evidence of dropping or abuse

test or inspection within the microwave generating

compartments, check the magnetron, waveguide or

transmission line, and cavity for proper alignment,

integrity, and connections.

(D) Any defective or misadjusted components in the

interlock, monitor, door seal, and microwave

generation and transmission systems shall be

repaired, replaced or adjusted by procedures

described in this manual before oven is released to

the consumer.

(E) Check microwave leakage to verify compliance with

the federal performance standard should be

performed on each oven prior to release to the

consumer.

Wiring

Good service practice is to never route wiring over

terminals and/or sharp edges. This applies to any wiring

without regard to the circuit voltage. Wire insulation

material and thickness is designed and regulated for

electrical spacing purpose only, but cannot always be

relied upon because of possible cuts and/or abrasions,

which can occur during servicing.

Important Safety Information

1 2 3 4 5 6 7 8 9 ... 26

Comments to this Manuals

No comments

Amana LD510D Service Manual Page 8

Comments to this Manuals

Related products and manuals for Microwaves Amana LD510D