Amana AOES3030 User Manual download pdf (Page 5)

Consider Description

Location

To eliminate the risk of burns or fire by reaching over heated surface units,

cabinet storage space located above the surface units should be avoided. If

cabinet storage is to be provided, the risk can be reduced by installing a range

hood that projects horizontally a minimum of 5 inches beyond the bottom of the

cabinets.

Use dimensions shown in this manual to determine space needed for

installation.

Cooktop must not be installed or stored in an area where it will be exposed to

water and/or weather.

Specialty Countertop Materials

Refer to manufacturer’s product information for instructions on handling specialty

countertop materials such as tile or ceramic. Countertop must be level for proper

cooktop installation.

Electrical Requirements

Electrical Supply

Cooktop needs a dedicated 120 volt, 60 hertz, 3 prong receptacle protected by a

15 amp circuit breaker or time delay fuse. A qualified electrician should confirm

the outlet is properly polarized and grounded. Wiring system and grounding

must conform with the latest edition of the National Electric Code, ANSI/NFPA

70, or the Canadian Electrical Code, CSA C22.1. Installation must conform to all

local, municipal and state building codes, and local utility regulations. Connect

cooktop to power supply with MAXIMUM RATED VOLTAGE listed on the rating

plate. Line voltage must not exceed rated voltage. Cooktop includes a 4-foot

power cord attached to bottom of cooktop at back, right corner

If a 2 prong outlet is encountered, cooktop owner must replace the outlet before

using the range. Do not cut off the cord, use a plug adapter or extension cord, or

remove grounding plug. Electrical supply should not converge on gas supply. Do

not ground electrical supply to gas lines.

Gas Requirements Gas Supply

Installation must conform with the latest edition of the National Fuel Gas Code,

ANSI Z223.1 or CAN1-B149.1 or B149.2 for gas burning appliances and

equipment. Installation must conform to all local, municipal and state building

codes, and local utility regulations.

In mobile housing, installation is to be in accordance with CSA standard Z241.1

gas equipped mobile housing. In manufactured (mobile) home installation must

conform with the latest edition of Manufactured Home Construction and Safety

Standard, Title 24 CFR, Part 3280. When that standard is not applicable, the

Standard for Manufactured Home Installation, ANSI 225.1/NFPA 501-A, or local

codes or the standard CAN/CSA-z240MH, “Mobile Homes” should be used.

Gas Supply Pressure

Appliance and individual shutoff valve must be disconnected from the gas

supply piping system during any pressure testing of that system at test pressures

in excess of ½ psig (3.5kPa) (14” WCP).

Appliance must be isolated from gas supply piping system by closing manual

shutoff valve during any pressure testing of the gas supply piping system at test

pressures equal to or less than ½ psig (3.5 kPa) (14” WCP).

Gas supply pressure for checking regulator setting must be at least 1” WCP

above manifold pressure shown on rating label.

Pressure regulator supplied with cooktop must be used.

CAUTION

To avoid property damage,

maximum gas supply

pressure must not exceed

14 WCP.

Installation Requirements

Before You Install

WARNING

To avoid risk of property

damage or serious personal

injury, use NATURAL GAS

only with this cooktop.

1 2 3 4 5 6

Comments to this Manuals

No comments

Amana AOES3030 User Manual Page 5

Comments to this Manuals

Related products and manuals for Ovens Amana AOES3030