Amana NTW4516FW Use and Care Guide Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 36
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
4
Control Panel and Features
WATER LEVEL
Set the Water Level knob to the Auto Sensing setting and
the washer will automatically sense the appropriate water
level for the load size and type.
Set the Water Level knob to the Deep Water Wash setting
and the washer will ll to the maximum water level.
NOTE: Cycle times will be longer due to extended ll times
when using the Deep Water Wash setting.
WASH TEMPERATURE
Wash Temperature senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric
and soils being washed. For best results and following
the garment label instructions, use the warmest wash
water safe for your fabric.
On some models and cycles, warm and hot water may
be cooler than your previous washer.
Even in a cold and cool water wash, some warm water
may be added to the washer to maintain a minimum
temperature. All rinses are cold.
WASH CYCLE KNOB
Use the Wash Cycle knob to select cycles on your washer.
See “Cycle Guide” for detailed descriptions of cycles.
START/STOP/PAUSE/UNLOCK LID BUTTON
Press to start the selected cycle; press again to pause
the cycle and unlock the lid.
NOTE: If the washer is spinning, it may take several
minutes to unlock the lid. Press and hold for 3 seconds
to cancel a cycle.
1
2
5
CYCLE STATUS LIGHTS INDICATOR
The Cycle Status lights show the progress of a cycle.
At each stage of the process, you may notice sounds
or pauses that are different from your previous washer.
SENSING/FILL
When the Start/Stop/Pause/Unlock Lid button is pressed,
and the Water Level knob is set to Auto Sensing, the
washer will ll and begin sensing to determine load size
and balance.
Once sensing is complete, the washer will ll to the
appropriate level for the detected load size and then
begin the wash phase of the cycle.
NOTE: Sensing and wash phases will be paused by
opening the unlocked lid. Close the lid to resume the
cycle. If the lid is left open for more than 10 minutes,
the washer will cancel the cycle and pump out the water.
The lid will lock after the wash phase to begin the initial
spinout and remain locked for the remainder of the cycle.
WASH
The washer will ll to the correct water level based on
the load size and the Water Level selection. Certain cycles
may agitate during the ll process to boost cleaning. You
will hear the agitator rotate, followed by a pause lasting
several seconds. When the wash cycle begins, you will
hear the agitator increase speed. The motor sounds may
change at different stages in the wash cycle while the
washer performs different wash actions.
3
4
Not all features and options are available on all models.
Appearance may vary.
5
1
4
3
2
Page view 3
1 2 3 4 5 ... 36

Comments to this Manuals

No comments