Amana ARG7300 Owner's Manual download pdf (Page 7)

Electrical Connection Requirements

Range must be electrically grounded in accordance with

local codes or in the absence of local codes, with the

National Electrical Code, ANSI/NFPA No. 70-Latest

Edition. In Canada, electrical connections are to made in

accordance with CSA C22.1 Canadian Electrical Code.

Use a 120 volt, 60 hertz, 3-prong receptacle protected by

a 15 amp circuit breaker or time delay fuse. A qualified

electrician should confirm the outlet is properly grounded.

If a 2-prong outlet is encountered, range owner must

replace outlet before using range. Do not cut off cord, use

plug adapter, or remove grounding plug.

Electrical Connection Clearance

Electrical connection must be located in the area shown in

Figure below. Electrical connection must not interfere with

gas connection.

A—2 inches (Both sides)

B—19½ inches

C—12 inches

D—6 inches

WARNING

To avoid the risk of serious electrical shock or

property damage, do not cut or remove the third

(ground) prong from the power plug. A 3-wire

grounded conductor system must be used. Relying

on the flexible connector, hard piping or any other part

of the gas supply line as a ground may cause fire,

electrical shock and/or erratic control operation.

Rectangular Anti-tip Bracket

1. Measure 3

/2 inches from back wall on right and left

side of cabinet cutout. Mark measurements on floor

and draw a straight line connecting marks.

2. Position anti-tip bracket.

• If range is installed beside cabinet(s), place anti-tip

bracket with back edge on line drawn on floor and

side of bracket against cabinet.

• If range is not installed beside cabinet(s), position

range where it will be installed. Draw a line along

side of range on floor from front to back. Remove

range. Place anti-tip bracket with back edge over

line drawn 3

/2 inches from back wall and side of

bracket over line drawn along side of range on floor.

• Anti-tip bracket can be installed on either right or

left side.

3 1/2"

3. Mark 2 hole locations in anti-tip bracket.

4. Drill 2 holes.

• If drilling into wood, use a

/32 inch drill bit.

• If drilling into concrete, use a

/16 inch masonry drill

bit and insert plastic anchors.

5. Secure bracket to floor using screws supplied.

6. Slide range into position.

7. Remove range storage drawer and confirm anti-tip

bracket is engaged with range leveling leg.

1 2 3 4 5 6 7 8 9 10 11 12 ... 51 52

Comments to this Manuals

No comments

Amana ARG7300 Owner's Manual Page 7

Comments to this Manuals

Related products and manuals for Cookers Amana ARG7300