Amana PTH093G Specifications download pdf (Page 31)

PROPER INSTALLATION

the HEAT key until appears, then press

the up and down arrow keys to select ( =

appears in the display).

For the bedroom unit closest to the main room in room

224, press the up and down arrow keys to select

02 (

appears in the display) Press the

key to exit configuration mode.

Binding of RF Devices

IMPORTANT NOTE: If wireless platform DP01*, DP01E or

DL01E are being utilized, then room numbers MUST BE CON-

FIGURED in the control board prior to binding wireless de-

vices.

DO NOT ATTEMPT TO BIND

MORE THAN ONE ROOM AT A TIME AT THE

SAME PROPERTY!!!

RF TRANSMITS THROUGH WALLS.

The wireless devices (DS01E and or DD01E must be bound

to the PTAC DT01E control for proper in-room communica-

tion. Ensure the unit is powered but in the OFF position.

NOTE: Both the DS01E and the DD01E must be bound to

the PTAC unit during the same “learn” opera-

tion.

If you need to rebind one device - then you

must rebind both devices during the same

learn mode event.

All must be bound at one time.

1. Press and hold OFF button on the PTAC until appears.

2. Press and then immediately release the white tactile

button on the back of the DS01* thermostat. should

now be displayed on the PTAC LED display. If does

not show on the display in 1-2 seconds, then press and

release the white button a second time. Skip this step

if there is no thermostat.

3. Press and then immediately release the white tactile

button on the back of the DD01* motion sensor.

should now be displayed on the PTAC LED display.

If or does not show on the display in 1-2 sec-

onds, then press and release the white button a second

time. NOTE: If both a DD01* and a DS01* are being

bound, then the display will show .

Skip if there is no motion sensor.

4. Press “OFF” on the PTAC touchpad to exit the binding

sequence.

5. Slide top of the thermostat down onto the wall plate

and then snap into place.

6. Provided optional security screws may be used in lower

corners of the thermostat.

OPTIONAL

SECURITY SCREWS

7. Snap motion sensor onto motion sensor mounting plate.

8. Provided optional security screws may be installed on

right and left side of the sensor.

9. If you wish to change from the factory default settings,

configure the device or devices that were bound. See

the next section for configuration choices.

NOTE: If a wireless device is replaced or added, all de-

vices (including those previously bound) will need to be

bound/re-bound to the unit. See directions above.

ENTERING ROOM NUMBER (SKIP IF NOT USING

DP01* FRONT DESK PLATFORM)

1. The PTAC control can be set for a 4-digit room num-

ber. To select the first two digits (floor), press the

HEAT key until appears, then press the

up down arrows to select the first two digits.

2. To select the last two digits of the room number,

press the HEAT key until appears, then

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 81 82

Comments to this Manuals

No comments

Amana PTH093G Specifications Page 31

Comments to this Manuals

Related products and manuals for Heat pumps Amana PTH093G