Amana PCC**C Installation Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
8
Compressor Protection Device
The PCC**C compressor includes components which are
designed to protect the compressor against abnormal
operating conditions.
WARNING
To avoid death or personal injury, always
disconnect electrical power before
inspecting or servicing the unit. All
compressor protection devices reset
automatically, energizing the contactor and
outdoor fan.
Operating Instructions
1. Turn on the electrical power supply to the unit.
2. Place the room thermostat selector switch in the COOL
or HEAT position (or AUTO if available, and if auto-
matic changeover from cooling to heating is desired).
3. Set the room thermostat to the desired temperature.
X. Maintenance
WARNING
To avoid death or personal injury due to
electrical shock, disconnect electrical
power before performing any maintenance.
Replacing Or Cleaning Filter
A return air filter is not supplied with this unit; however, there
must be a means of filtering all of the return air. The filter(s)
may be located in the return air duct(s), or return air filter
grille(s). Consult with your installing dealer for the actual
location of the return air filter(s) for your unit.
Dirty filters are the most common cause of inadequate
heating or cooling performance. Filter inspection should be
made at least every two months; more often if necessary
because of local conditions and usage.
Dirty throwaway filters should be discarded and replaced
with a new, clean filter. Dirty permanent filters should be
washed with water, thoroughly dried and sprayed with a
filter adhesive before being reinstalled. (Filter adhesives
may be found at many hardware stores.) Permanent filters
should last several years; however, should one become
torn or uncleanable, it should be replaced.
Maintaining Cabinet Finish
Use a fine grade automotive wax on the cabinet finish to
maintain the finish’s original high luster. This is especially
important in areas with high ultraviolet radiation.
Clean Outside Coil (Qualified Servicer
Only)
The coil with the outside air flowing over it should be
inspected annually and cleaned as frequently as necessary
to keep the finned areas free of lint, hair and debris.
Condenser and Evaporator Motors
Bearings on the evaporator motor and the condenser motor
are permanently lubricated. No additional oiling is required.
WARNING
To avoid death or personal injury due to
electrical shock, do not remove any internal
compartment covers or attempt any
adjustment.
CAUTION
Verify proper operation after servicing.
XI. Accessories
Over-Under to Side by Side PDTROU4A
Roof Curb - Universal (PRC08A1)
Accessory
Single Point Power Connection (SPK**A)
Roof Curb - Heat Pump/AC (PRC06A1)
Horizontal Duct Covers (CHK001A)
Heater Kit Kw BTUH
L1-L2 L3-L4 L1-L2 L3-L4
PHCB05C1 5.0 16,400 25 -- 30 --
PHCB10C1 10.0 32,800 50 -- 60
PHCB15C1 15.0 49,100 50 25 60 30
PHCB20C1 20.0 65,600 50 50 60 60
Heater Capacity @ 240 VAC
Minimum
Circuit
Ampacity
Maximum
Overcurrent
Protection
Additional Amana accessories, as described above, can be
purchased to fit specific application needs. Accessories
can be ordered by the part numbers in the table and each
accessory includes its own separate instructions.
Replacement Parts
Refer to the description in the Parts Catalog when ordering
any part. Be sure to provide the unit model, manufacturing,
and serial numbers with the order.
Note: Details for installing and wiring electric heater kits
and single point wiring kits are contained in the installation
instructions for these accessories.
Page view 7
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments