Amana MVH230* User Manual download pdf (Page 4)

Installation Instructions

Outside Back Exhaust (Horizontal Duct)

1. Slide exhaust adaptor to one side, squeeze sides and

remove. Save damper and exhaust adaptor. See

diagram above.

2. Remove and save 3 screws holding blower plate to

microwave oven.

3. Lift off blower plate.

Outside Top Exhaust (Vertical Duct)

1. Slide exhaust adaptor to one side, squeeze sides and

remove. Save damper and exhaust adaptor.

2. Proceed to "Preparing Top Cabinet".

2. Remove 2 screws from mounting plate, as

shown above. Plate will be used as rear wall

template.

3. Locate separately packed grease filters and hardware

packet.

4. Remove any adhesive tape on exhaust

adaptor, grease filters, and power supply cord.

B. Preparing Microwave Exhaust Duct

This microwave oven is designed for adaptation to the

following three types of ventilation.

• Outside Top Exhaust (Vertical Duct)

• Outside Back Exhaust (Horizontal Duct)

• Recirculating (Non-vented/Ductless)

Select type of ventilation required for your installation and

proceed to that section.

NOTE: Microwave oven is shipped assembled for top

exhaust. Adjustments will need to be made to

assure proper alignment with current exhaust duct

after microwave oven is installed.

A. Removing Mounting Plate

1. Place protective blanket on work surface to

protect outer case of microwave oven. Place

microwave oven on control panel side.

4. Remove and save the screw that holds blower motor

to microwave.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Amana MVH230* User Manual Page 4