Amana Commercial Service Manual download pdf (Page 2)

RS2240002 Rev. 1 2

WARNING

To avoid risk of electrical shock, injury, or death, make

sure these grounding instructions are followed.

Grounding Instructions

WARNING

Do not remove grounding prong when installing

grounded appliance in a home or business that does

not have three wire grounding receptacle, under no

condition is grounding prong to be cut off or removed. It

is the personal responsibility of the consumer to

contact a qualified electrician and have properly

grounded three prong wall receptacle installed in

accordance with appropriate electrical codes.

Should a two prong adapter plug be required temporarily

it is the personal responsibility of the consumer to have it

replaced with properly grounded three prong receptacle or

the two prong adapter properly grounded by a qualified

electrician in accordance with appropriate electrical

codes.

Servicing of Grounded Products

The standard accepted color coding for grounding wires

is GREEN or GREEN WITH YELLOW STRIPE. These

ground leads are NOT to be used as current carrying

conductors. It is extremely important that the technician

replace any and all grounds prior to completion of the

service call. Under no condition should ground wire be left

off causing a potential hazard to technicians and

consumer.

Important Product Information

WARNING

Precautions to be observed before and during servicing

to avoid possible exposure to excessive microwave

energy.

(A) Do not operate or allow oven to be operated with the

door open.

(B) Make the following safety checks on all ovens to be

serviced before activating the magnetron or other

microwave source, and make repairs as necessary:

• Interlock operation

• Proper door closing

• Seal and sealing surfaces (arcing, wear, and other

damage)

• Damage to or loosening of hinges and latches

• Evidence of dropping or abuse

test or inspection within the microwave generating

compartments, check the magnetron, wave guide or

transmission line, and cavity for proper alignment,

integrity, and connections.

(D) Any defective or misadjusted components in the

interlock, monitor, door seal, and microwave

generation and transmission systems shall be

repaired, replaced, or adjusted by procedures

described in this manual before oven is released to

the consumer.

(E) Check microwave leakage to verify compliance with

the Federal Performance Standard should be

performed on each oven prior to release to the

consumer.

WIRING

Good service practice is to never route wiring over

terminals and/or sharp edges. This applies to any wiring

without regard to the circuit voltage. Wire insulation

material and thickness is designed and regulated for

electrical spacing purpose only, but cannot always be

relied upon because of possible cuts and/or abrasions,

which can occur during servicing.

1 2 3 4 5 6 7 ... 59 60

Comments to this Manuals

No comments

Amana Commercial Service Manual Page 2

Comments to this Manuals

Related products and manuals for Microwaves Amana Commercial