Amana Commercial Service Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 60
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
9 RS2240002 Rev. 1
Installation
Radio Interference
Microwave operation may cause interference to radio,
television, or similar equipment. Reduce or eliminate
interference by doing the following:
Clean door and sealing surfaces of oven
according to instructions in "Care and Cleaning"
section.
Place radio, television, etc. as far as possible from
oven.
Use properly installed antenna on radio, television, etc.
to obtain stronger signal reception.
Grounding Instructions
NOTE: Do not under any circumstances cut or remove
grounding prong from the plug or bend power
prongs to fit receptacle other than one shown for
your equipment. Such abuse of the plug can
result in electrical shock or overheating.
WARNING
!
Improper use of grounding plug can result in a risk of
electrical shock or death.
This equipment MUST be grounded. In the event of an
electrical short circuit, grounding reduces risk of electric
shock by providing an escape wire for electric current.
This oven is equipped with a cord having grounding wire
with a grounding plug. Plug must be plugged into an
outlet that is properly installed and grounded. DO NOT
use a two-prong adapter.
Consult a qualified electrician or servicer if grounding
instructions are not completely understood, or if doubt
exists as to whether the equipment is properly grounded.
Do not use an extension cord. If product power cord is
too short, have a qualified electrician install an
appropriate receptacle. This equipment should be
plugged into a separate 60 Hz circuit with the appropriate
electrical rating as shown in the drawings. When an oven
is on a circuit with other equipment, an increase in
cooking times may be required and fuses can be blown.
Unpacking Oven
Remove packing and printed material from ovencavity.
Inspect oven for damage such as dents
in door or inside oven cavity.
Report any dents or breakage to source of
purchase immediately. Do not attempt to use oven if
damaged.
If oven has been stored in extermely cold area, wait a
few hours before connecting power.
Oven Placement
Do not install oven next to or above source of heat,
such as pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could
shorten life of electrical parts.
Do not block or obstruct oven filter. Allow access for
cleaning.
Install oven on level countertop surface.
A
B
A
A
B
A
A—Allow at least 7" (17.8 cm) of clearance around top
and sides of oven. Proper air flow around oven cools
electrical components. With restricted air flow, oven
may not operate properly and life of electrical parts
is reduced.
B—Allow at least 2
9
/16" (6.5 cm) between air discharge
on back of oven and back wall.
Model NEMA
Designation
Receptacle and
Plug
HDC10
HDC12
NEMA
5-20R/5-20P
120V-20AMP
HDC18
HDC18SD
HDC21
NEMA
6-20R/6-20P
250V-20AMP
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 59 60

Comments to this Manuals

No comments