32
!
WARNING
To avoid risk of electrical shock, personal injury or death; disconnect power to oven and discharge capacitors
before following any disassembly procedures.
Convection Temperature Test
Convection Temperature Calibration
: It is absolutely necessary to own and use a
thermocouple type oven tester to accurately
measure oven temperatur e. No other type of
thermometer can take its place.
NOTE: It is normal for the average oven temperature
to vary from the oven setting by as much as
mind.
NOTE: Before testing an oven to check calibration,
inspect the RTD for proper mounting.
Calibration
Place one wire rack in center position. Remove
any other racks and utensils.
NOTE: Door must be closed and unit must be in
STANDBY mode.
2. Clip thermocouple to the center rack and run lead
outside oven door, or wrap thermocouple around
rack and have the tip of thermocouple extend
upward towards top of cavity approximately 1".
1. Press HIDDEN PAD.
2. Press pads 1,3,5,7, 9.
3. Press "0" pad.
3. Press PREHEAT ON/OFF pad.
STG
COOK
PREHEA ST TANDBY
ITEM
POWER
C M
1
2
3
4
QTY
LEVEL
NOT READY
LMT
Press PROGRAM SAVE pad.
5. Press TEMP pad.
6. Enter 450°F.
7. Allow oven to cycle one time.
8. Record high and low peaks from next two cycles.
NOTE:
NOTE: Display does not
indicate if heating elements
4. Press the "0"
Fahrenheit Example:
Fahrenheit
LOW
HIGH
NOTE:
and advances in 2 and 3° increments.
1 440°F 460°F
Cycle 2 439°F
461°F
Celsius
879°F + 921°F = 1800°F
NOTE:
and advances in 1 and 2° increments.
1800°F / 4 = 450°F average temperature
5. Press STOP/RESET
Celsius Example:
NOTE:
made.
LOW
HIGH
1 230°C 240°C
Cycle 2 230°C
240°C
Fahrenheit Example:
t Oven temperature is set for 450°F
460°C + 480°C = 940°C
t Average of temperature test is 475°F
940°C / 4 = 235°C average temperature
t
If the average temperature is too high or too low the
t
is shown in the display (10 – 25 = –15)
Celsius Example:
t Oven temperature is set for 230°C
t Average of temperature test is 240°C
t
t
shown in the display (5– 10= –5)
F
TEST MODES
Comments to this Manuals