Amana AAC051SRA Service Manual download pdf (Page 22)

Disassembly Procedures

[ ,Ek WARNING

To avoid risk of electrical shock, personal injury, or death, disconnect electrical power source to unit and

discharge capacitor through a 10,000 ohm resistor before attempting to service, unless test procedures

require power to be connected. Ensure all ground wires are connected before certifying unit as repaired

and/or operational.

]

4. Unbraze condenser discharge connection to

compressor.

5. Unbraze condenser connection shown below.

6. Lift condenser up and away from chassis.

Unbraze Here

Condenser Removal

Compressor Overload Protector Removal

To remove compressor overload protector:

1. Remove chassis (see Chassis Removal).

2. Remove nut securing terminal cover to

compressor, then lift terminal cover up and away

from compressor.

3. Disconnect overload protector leads.

4. Lift overload protector up and away from

compressor.

Overload Terminal Cover

Protecto /

Compressor Overload Protector Removal

Compressor Removal

To remove compressor:

1. Remove chassis (see Chassis Removal).

2. Remove compressor overload protector (see

Compressor Overload Protector Removal).

3. Disconnect leads on compressor.

Note: Before opening any refrigeration system,

capture refrigerant in system for safe disposal.

4. Evacuate sealed system (see Evacuation in

Troubleshooting Information section).

[ CAU'nON J

To reduce risk of personal injury or property damage,

take nescessary precautions against high

J temperatures required for brazing

22 16022061 Rev. 0 @2003 MaytagAppliancesCompany

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 41 42

No comments

Amana AAC051SRA Service Manual Page 22