Amana AAC051SRA Service Manual download pdf (Page 35)

iNSTALL OUTER

CASE IN WINDOW

Place outer case in window. Lower sash

until it rests behind front flange of top rail.

Bottom rail must rest behind window sill.

.....-Curtain assembly

.... removed for clarity.

Expand both curtains to contact the

window frame. Install five 25-mm screws

through curtains and top rail. Install two

outer case anchor screws into window sill.

NOTE: To make screws eas_er to drive,

drill a 1/8' diameter pilot hole into sash

through clearance hole in curtains and top

Install outdoor supports on under

side of outer case. Mount outdoor

supports as close to sill as possible.

,CAUTION: Use a hard wood block

between the adjusting foot and the

surface it may contact. This will

protect the surface from damage.

Turn each adjusting foot until it

begins to contact wood block, With a

level adjust unit to a 1/2 bubble slope

rail. to the rear for proper water drainage.

BASEPAN ANGLE |

& WINDOW SEAL -.. |

GASKET _ /

Position baspan an le flush a ainst |

g g _ |

outercase. Drive 25-mm screws _ J _ |

into window ledge to prevent unit _ ...._ _ /

from moving. _ |

Cut window seal gasket to wndth of _/." ._.-:':__ /

w,ndow. Stuff w,ndow seal str,p |

between outdoor window glass and /

top of indoor sash. This will stop air -_. IIilIlllJII _ _ |

leakage which reduces efficiency. J_l_ /

25-mm /._/x.......<_ ! /

screws jl_._ _., /

Basepal_ " J

angle

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 41 42

No comments

Amana AAC051SRA Service Manual Page 35